/ Metrology Equipment / Laser Measurement Systems / Tire Industry Products / Off-Line Profilometer / OFLP-600-30 * Not actual product image Off-Line Profilometer Other similar products The Starrett-Bytewise Profilometer was developed as an automated, non-contact measurement system to displace checking with hand tools. The Profilometer is used to verify the accuracy of newly-cut dies by checking the extrusion dimensions. Its accuracy and speed helps reduce the number of die trials needed to approve a new die for production. Once in production, the Profilometer is used to check each run for overall quality, and to monitor for die wear. The Starrett-Bytewise Profilometer can help you improve your extrusion quality, reduce raw materials cost, and reduce extruder down-time for die trials. Features Specifications Downloads Contact Starrett Features The Laser Sensor feature is optimized for accurate measurements on black rubber The Thermal Protection feature turns sensors off at 45 degrees Celcius The Servo-motor linear axis provides accurate and repeatable scan control The Dual Axis Option permits averaging for up to three side-by-side scans The Import Specifications feature imports XY break points from a data table The Gauge Report lists the measured thickness values at each breakpoint along with the design specification and error amount The Point Report lists the measured width values at each breakpoint along with the design specification and error amount The Symmetry Report compares the right and left side point width, thickness, region area, and center of gravity The Regional Report analyzes the area and center of gravity The Conicity Report compares the area distribution of one side of the extruded component to the other side The Graphical Overlay compares multiple runs The INI file is used for configuration for testing and reporting schemes The Optimized Calibration feature measures 16 thickness values and 4 angle values to assure accuracy across the entire range The PC Controller allows easy replacement of a standard HP desktop PC from a local source The IPC Option allows the customization of an Industrial PC per the customer's specifications The Remote Support feature enables software updates and training via the Internet via a secure link Specifications Width Range: 600 mm or 1000 mm Thickness Range: 30 mm or 60 mm Width Accuracy: 0.0125 mm Width Repeatability (1s): 0.0125 mm Thickness Accuracy: 0.0125 mm or 0.0250 mm Thickness Repeatability (1s): 0.0125 mm or 0.0250 mm Thickness Resolution: 0.00875 mm or 0.0175 mm Area Accuracy: 0.025% Area Repeatability (1s): 0.025% Laser Spot Diameter, Top: 0.1 mm or 0.3 mm Laser Spot Diameter, Bottom: 0.1 mm Width Point Spacing: 0.1 mm Dual Axis Range: 20 mm Cycle Time: 30 sec or 50 sec Laser Frequency: 16 kHz Laser Resolution: 0.008 mm Current at 230V: 10 A Laser Classification, CDRH: IIIb Laser Classification, IEC: 3b Low Voltage Directive: Yes EMC Directive: Yes Machinery Directive: Yes Downloads Representative Contacts for Laser Measurement Systems - Tire Industry List of international sales contacts and factory locations for laser measurement systems design for tire manufacturing. Precision Hand Tools (Catalog 33) 612 page catalog featuring precision hand tool, force measurement, vison systems, optical comparators, laser measurement, and flat stock.