/ Precision Measuring Tools / Precision Hand Tools / Indicators & Gages / Special Function Dial Gages / 696ZWOB * Not actual product image 52904 696ZWOB Strain Gage W/O 696B 52904 Other similar products Ideal gage for checking bearing alignment or shaft deflection without dismantling the engine. Also useful as a strain gage on engine frames. This inside measuring gage checks the distortion of crankshaft webs and bears a direct relation to existing misalignment or excessive bearing wear. Used on all diesel engine shafts and center crankshafts on any type of engine or compressor, the gage can also be applied as a strain gage on engine frames while the engine is operating. A comparison of readings taken at top and bottom positions indicates any misalignment of cylinder and frame which results in local over-stress and eventual cracking of the frame neck. Gage w/o Balancing Attachment, 2 3/8-18" Range neck. Features Specifications Contact Starrett Features The dial indicator movement is approximately 5/32" (4mm) and with rods and extension, provides a range from 2 3/8-18" or 61-458mm There are 10 rods and one extension furnished Rods are marked to designate the approximate overall length of the gage Indicator has a movable bezel to adjust the dial in relation to the hand and a non-breakable crystal Designed in collaboration with Hartford Steam Boiler. Gage is used by their inspectors to check the distortion of engine shafts and frames Specifications Type: Strain Gage Range (in): 2- 3/8" to 18" Graduations (in): .001" Dial Reading: 0-20-0 / .040" Rev.